[Problème de purge dans Cura sur double extruder.]

as tu resolu ton probleme ?

de mon coté les changements de couleurs ne sont pas beaux...............

 

j'ai tenté l'installation d'un bassin de purge mais cura ne veux pas reconnaitre le Gcode !!!

 

je suis nouveau en 2 couleurs pour info

[cura not accept Gcode]

Hello everyone,

cura do not want to recognize this gcode and he continues to go to make a purge tour even if it is disabled (in this case it moves but does not)

note: tests done "without filament" because after more than a month it is expensive!

if you could help me it would be nice!

cura 4.2.1

 

to be clear, I would like to set up the purge tank on geeetech A20M instead of the purge tower. the gcode has been taken from guero among other ....