Jump to content

ericdu62

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. as tu resolu ton probleme ? de mon coté les changements de couleurs ne sont pas beaux............... j'ai tenté l'installation d'un bassin de purge mais cura ne veux pas reconnaitre le Gcode !!! je suis nouveau en 2 couleurs pour info
  2. Hello everyone, cura do not want to recognize this gcode and he continues to go to make a purge tour even if it is disabled (in this case it moves but does not) note: tests done "without filament" because after more than a month it is expensive! if you could help me it would be nice! cura 4.2.1 to be clear, I would like to set up the purge tank on geeetech A20M instead of the purge tower. the gcode has been taken from guero among other ....
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!