Huwied
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Huwied
-
-
-
Hi GR5, Thanks for the response.....
Im pretty sure its the model. Attaching few screenshots from cura. There are red areas in x-ray but those areas have printed correctly its more the nose section is the issue. Hard to tell from the slice but you can see the layers which i presume look correct.
Checked the machine over it feels new, no slop, float etc etc feels nice and tight as new.
-
Hi all,
Having a bit of a head scratcher with a print.
Original was drawn in f360 then sliced in Cura.
I tried to print the whole thing downscaled but the front section and underneath seem to have separation issue / thin walls, the middle section is correctly filled and good quality. I had set the walls to 2mm but still have the same issue. I am using the correction options in Cura.
Following on I cut the model and changed orientation but the issue is following me and now exaggerated. I can’t for the life of me figure out why the fill isn’t the same throughout or why I’m still getting the thin walls ( quite new to all this)
Can anyone point me in the right direction.
Thanks in advance....
Print degrading at top / settings issues
in Improve your 3D prints
Posted
Hmmm..... was created in fusion.... I guess I need to go back and seal it up.... ( after figuring out how ) still getting to grips with it, all this is very new to me..... thanks for the pointers really appreciate it !!