ewatson
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by ewatson
-
-
Thank you so much burtoogle... your solution worked well. I don't want to get into the weeds, but what is meant by the "model normals".
Thank you!
-
The attached model has a 6.35 mm circular indentation that won't print on the UM3E when facing down. I haven't tried to print in inverted (indentation on top) but would like to avoid that solution (not to say it would even work) since it will require additional supports, etc.
Printing Nylon Structure with PLA Support
in Materials & profiles
Posted
There is a component I am printing in high volume and I have recently made the change from PLA to NYLON because of NYLON's strength. However, when I print the supports for this NYLON structure using NYLON I find the supports almost impossible to remove. Because of this I have tried printing the supports with PLA. However, the NYLON doesn't seem to make an important connection to the PLA. Does anyone have any recommendations for printing supports for a NYLON print?