UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Well im a few years late but I know this is the solution to the original problem and hope it helps someone. Once Cura starts up fallow the below tabs is that doesn't make sense I attached a photo too.
ONCE YOUR IN CURA
Preferences > Configure Cura > Settings > Build Plate Adhesion > Extruder Prime X PositionOR Extruder Prime Y Position, you can also turn the blob at the end off or on as well in that same area. 😃
How do I get Cura to print a test strip before starting the actual print?
in UltiMaker Cura
Posted · Edited by jeremyfiller1986
Typo
Well im a few years late but I know this is the solution to the original problem and hope it helps someone. Once Cura starts up fallow the below tabs is that doesn't make sense I attached a photo too.
ONCE YOUR IN CURA
Preferences > Configure Cura > Settings > Build Plate Adhesion > Extruder Prime X Position OR Extruder Prime Y Position, you can also turn the blob at the end off or on as well in that same area. 😃