PieterLemmens
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by PieterLemmens
-
-
Similar issue here.
model S5, updated firmware and i have reset factory settings.
But i noticed: the colder it gets outside... the more often the problem...
I had a small heater near the printer ( about 0.5m away). I think it might be causig an interference. The warm air raising next to the printer may cause some ESD issues??? It's a large volume of moving air.@dmanthei, you also have an air unit nearby? You might want to move that one and test.
Anyway. Just sharing my thoughts here.
Rgds
P
-
I'm having the same issue... Is there any update on this matter?
-
Hi there,
I have the same question, especially the ABS+ from ICE.
I've printed the PLA 2 years ago. That worked out pretty nice.
thanks
Pieter
UltiTuner, a tool to tweak your printer
in UltiMaker 3D printers
Posted
Hi @Smithy,
I'm looking for some additional information on the webcam. Is there a brief manual for that? Can i plug in a usb webcam to the USB interface in the S5?
Thanks
Pieter.
Ps: the disabling of the leveling works fine.