emco
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by emco
-
-
-
can't see them? .. try this
(Edited first post)
-
Hi there,
I've got that following issue with cura 4.3 (using Ultimaker S5 Printer)
The model i want to print is standing on 4 feets (as you see in the screenshots below)
Model 1:
Model 2:
Now.. the base of the model which stands on the 4 feets obviously needs to be supported.
Im working with the standard printer settings except the support structure setting, with is set toGenerate Support: YES
Support Extruder: Extruder 2The first layer of the models base is layer 20. So the last support layer is layer 19.
I expected the layer 19 to be a "full" printed support layer (so that the models base is supported correctly).
What the cura 4.3 slicing output is, is the following screenshots (model color: red).cura 4.3 layer 19 (what the..?!):
cura 4.3 layer 20 (...can't print on air..):
With cura 4.1 i installed a later version and sliced again with the same settings (pic 5, model color: green)
cura 4.1 layer 19:
So .. is this a known issue? Are there any mistakes i did?
Thanks
Timo
Support Material Slicing Issue with Cura 4.3
in UltiMaker Cura
Posted
Hi everyone,
Update:
- the problem reacts to the setting "Support Horizontal Expansion"
If i slice my acutal file with the following settings, i get the following results
0 => no print on air
1 => print on air
2 => print on air
3 (default) => no print on air
For my initial post, i'm 100% sure that i used the default settings
For my last post on feb.27 im not sure about the "Support Horizontal Expansion" setting
So now that i described the problem and even served a possible solution, i hope for some more reaction.
will keep you updated...