Jump to content

scotg1107

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I'm struggling on what to even call what I'm looking for I would consider it an internal support but it is on the infill section of the part. I have a low infill density and sections of the part start out floating in mid air. I know the easy way to fix this is to bump up the infill but on a part this size that increases the print time and is really just wasting filament . Is there a way to add support or extra infill in certain regions of a part without just increasing overall infill density. I've attached a couple pictures that hopefully help explain what I need. Thanks Scot
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!