Hi,
I have recently purchased an Ultimaker 2+. I have had a lot of difficulty printing successfully. I have tried multiple filaments, and print settings, and have purchased the refresh kit, which is a new print bed, and heater, thermocouple, fans, nozzle, ect.
I have tried different layer height, infill, retraction, ect. I have noticed that for some prints material will not even come out of the print head. I will always try to 'move material' right before a print to see if the filament is set correctly and I get material to come out of the nozzle so I know its not clogged. What happens is when the print starts it does a slight retraction and when that happens the material gets stuck on something before it is able to make it to the nozzle. So there is no material that comes out after I start a print, but I can get material to come out when I 'move material' right before I try to print.
I don't know why the filament gets stuck. Is there a mod or something I can do to keep the filament from getting stuck right before it enters the nozzle..