UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So i need to print a couple of lines in a structure like this:
The single lines should be a different .stl file I have been told. And I already have a geometry.
The problem comes when loading into Cura. Cura either says the file is too small. As i am printing the vertical lines in surface mode to make sure there is only one pass.
This problem i have sort of fixed by making these bigger geometries. However now everytime cura tries to slice this a lot of beams fall away. This happens very irrigularly.
I hope some of you guys can help.
These are the models if i can load them into cura. This still wont be seen in the slicing.
Single line print too small to load
in UltiMaker Cura
Posted
So i need to print a couple of lines in a structure like this:
The single lines should be a different .stl file I have been told. And I already have a geometry.
The problem comes when loading into Cura. Cura either says the file is too small. As i am printing the vertical lines in surface mode to make sure there is only one pass.
This problem i have sort of fixed by making these bigger geometries. However now everytime cura tries to slice this a lot of beams fall away. This happens very irrigularly.
I hope some of you guys can help.
These are the models if i can load them into cura. This still wont be seen in the slicing.