ColinM

Ok solved refreshed API number in Octoprint Saved it then copied it back into CURA then disconnected and reconnected it then it appears to be working!!! I looked in the log files when it was failing and although I had the correct IP address in the Box above ending 0.15 the log showed 0.15 I assume this must be from not updating the API correctly. Although I dont understand how CURA could see the webcam but not connect to printer Ill see how it goes - thanks for help

I even added API that I copied within octoprint to cura same result!!

I pressed connect and then Request whent went to web I pressed allow as below but back in cura it did not have API code and Error still occurred

Ok will look later thanks

This is how it looks in Cura

https://1drv.ms/u/s!ApTZLEEGXnTzgrgBnHjPGx3518RtrA?e=s5Xlft I hope this helps

octoprint 1.3.12. plugin 3.5.11 Not sure how to send log file but looking in it there are loads of "tornado.access - WARNING - 409 "

I have recently got this problem where cura keeps putting up pop up with the words "Octoprint error forbidden" And although after slicing it says "print with octoprint" and it says it will queue the print it doesnst send or store the print to octoprint. I can see the camera attached to the pi 3b+ in the monitor tab bu on that tab it says "Printer does not accept commands" If i go to octoprint in web browser I can control upload and print as usual - its just the Cura link that is not working. This was all working fine at the weekend