[Cura partial selection]

Hi there.

I am currently using Ultimaker Cura 4.4.1

I would like to be able to select a part of an object with a selection tool  (rectangle, circle or freehand) and set settings for that selected part separate.

I know i can do this in the gcode, but it requires a good knowledge of coding and it is  not a user-friendly way.

 

Is there perhaps a plugin available that can do just that? Or is this something  that Cura can implement in future versions?

[Cura adds unwanted geometry to my object]

I think i have figured it out. In "Experimental", "make overhang printable" was checked.

After i turned it off, the extra geometry disappeared.

 

Thanks for the effort anyway.

[Cura adds unwanted geometry to my object]

Alright i installed 4.4.1 but my problem persist.

I am  pretty sure that my settings in Cura are off but i can't seem to figure out witch setting could have such influence to my object.

I will add the obj file. Perhaps you can see something i have overlooked.

Test_Block.obj

[Cura adds unwanted geometry to my object]

Sure thing. I will let you know how that works out for me. 😉

[Cura adds unwanted geometry to my object]

Hi. Thank you for your quick reply.

I am currently working with Cura 4.2.0

The 3mf file is attached.

Blokus-Piece.3mf

[Cura adds unwanted geometry to my object]

Hello .

 

I have a situation in Cura witch i have not be able to solve or found any topic about this.

Here i have just a simple L-shaped piece with some blocks on both sides. Dimensions: 24.4mm x 24.4mm x 6.7mm.

Nothing special. Now, ones it is sliced in Cura, extra geometry is added in the bottom of my piece right between each block from the bottom up.

So far i have rotated the object, changed the infill, toggled support on and off and re-scaled the object both inside as outside of Cura.

None of these changes got rid of the extra geometry.

I think i may have to change some settings in Cura. Any one any suggestions?

 

Thanks.