Hello .
I have a situation in Cura witch i have not be able to solve or found any topic about this.
Here i have just a simple L-shaped piece with some blocks on both sides. Dimensions: 24.4mm x 24.4mm x 6.7mm.
Nothing special. Now, ones it is sliced in Cura, extra geometry is added in the bottom of my piece right between each block from the bottom up.
So far i have rotated the object, changed the infill, toggled support on and off and re-scaled the object both inside as outside of Cura.
None of these changes got rid of the extra geometry.
I think i may have to change some settings in Cura. Any one any suggestions?
Thanks.