Jump to content
Ultimaker Community of 3D Printing Experts

MJ27

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hey Guys! We've had to scrap quite a few prints that required the Material Manager to swap to the next roll of similar filament mid-print. However, we've found out that if we cut off the bend in the end of the filament, our Material Managers have no problem. What we observe is the bend at the end of the filament gets caught and the Material Manager's feeder will just spin out on the filament, causing a non-recoverable error (usually ER59) and scrapping the print. It's also worth noting that we use mostly Ultimaker Tough PLA and Breakaway. It's nice that we c
×
×
  • Create New...