UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Same problem for me, only all the time not just after a windows restart. Cura worked great for about 2 weeks then started asking for setup again at nearly every launch. I've just started opening a half dozen instances of cura back-to-back and usually at least 1 of them will open the way it should, without asking to go through setup again. It's a ridiculous workaround, but it seems to work. Hopefully with the next update you can address this issue!
cura 4.3 asks for printer setup everytime it is stated after a windows restart.
in UltiMaker Cura
Posted · Edited by cambuehl
Same problem for me, only all the time not just after a windows restart. Cura worked great for about 2 weeks then started asking for setup again at nearly every launch. I've just started opening a half dozen instances of cura back-to-back and usually at least 1 of them will open the way it should, without asking to go through setup again. It's a ridiculous workaround, but it seems to work. Hopefully with the next update you can address this issue!