I'm running into a slight issue with Cura 4.5's Anet A8 profile (thank you VERY much for including it)
So on print end - the following gcode is executed:
M104 S0
M140 S0
G92 E80
G1 E-80 F2000
G28 X0 Y0
M84
Cura 4.5 is a MARKED improvement over the previous 4.x releases. Application is very stable and starts reliably now. Upon finishing a print yesterday, I heard an interesting noise (not bad just unexpected) of the extruder retracting on completion.
Today I went to run a print and kicked it off. I look over after the print completed and noticed nothing had printed out at all. I figured my filament got stuck (not remembering hearing the retract). I tried pulling out the filament manually only to have it get stuck. I let everything cool down and unbolted the cooling fan on the extruder body. Sure enough, there was a nice glob at the end of the filament below the hobbed gear.
I think the retraction setting is a bit excessive.
Any suggestions to tune this?
Thanks in advance.