Dublin1
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Dublin1
-
-
Hi,
I changed nozzle size from 0.4 to 0.6 and then I cannot access my profiles, I only get the standard profiles that comes with cura. When I tried to import one of my profiles into cure when 0.6 nozzle was selected I get a warning "This profile is not visible because quality type "super" is not available for this configuration.".
So to this I have two questions - how is quality type of a profile determined? The profile in question has no settings that should be in conflict with having a 0.6 nozzle.
- If I would like to start reconfiguring an old profile for use with a different nozzle size - how should I proceed when I cant open it into Cure when the other nozzle size is selected?
Cannot access my profiles after changing nozzle size * wrong "quality type"
in UltiMaker Cura
Posted
Thank you!
From your information I understand understood how it works and my solution now is to add a .inst.cfg file for my printer for super quality and 0.6 nozzle and then my profiles shows up. However I'm a bit worried that the file I added will be removed in future upgrades - anything you know about?
To me, the correct solution would be to change the quality type "super" in the profile. But when I try to do that in the exported file I only get error messages while trying to import the changed file. Is there any way to change quality type in a existing profile?