UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Updated to 4.6, sliced my print with ironing on and after an ironing layer the flow is not returned to the usual print rate to carry on so the print fails as it doesn’t extrude enough. I have re sliced and restarted but 3 failed prints now and the exact same point. If I manually go into settings on my printer it shows 10% flow and if I increase it back to 100 then the filament does start flowing again but obviously too late.
is this an issue known or can you think why this is happening??
How does the change back to normal flow get represented in the Gcode ? and then I can check if it is returned to normal as I can’t find any m221s in there.
Ultimaker Cura 4.6 released
in UltiMaker Cura
Posted
Updated to 4.6, sliced my print with ironing on and after an ironing layer the flow is not returned to the usual print rate to carry on so the print fails as it doesn’t extrude enough. I have re sliced and restarted but 3 failed prints now and the exact same point. If I manually go into settings on my printer it shows 10% flow and if I increase it back to 100 then the filament does start flowing again but obviously too late.
is this an issue known or can you think why this is happening??
How does the change back to normal flow get represented in the Gcode ? and then I can check if it is returned to normal as I can’t find any m221s in there.