[Overhang Support???]

yes it says it cant open that type of file,  Wow 3 hrs would be awesome

 

[Overhang Support???]

Thanks obewan and tinkergnome

 obewan your file wouldn't open. I did download Mesh tools and got the rectangular tube to be recognized. played around with different settings had it looking good tried to change infill density and it greyed out at 25 percent cant change it. wanted to lower it trying to get print below 24hrs. At 25 percent will be to heavy . What infill pattern would you recommend? Any thoughts??

 

Brian

[Overhang Support???]

Thanks for the response ungutknut

 

 I did try to set the angle in Cura but wouldn't accept 90 deg. for the angle I think it was set at 60.

not sure if i did it right will try again

 Brian

[Overhang Support???]

Corner block for strap clamp.STLI am new to 3d printing and was successful until I started messing with the settings in Cura. I am trying to print this part(Corner Block) but in Cura the overhang is turned into a angle  I'm assuming the 60 deg. that is set in Cura, How can I fix this?  Another issue I have had is that this Wing part (WR2) has a rectangular tube running thru it that I cant get Cura to recognize. It gets filled with the inner support structure. I have 3 left and 3 right parts to print all with the same rectangular tube running thru them.

Any advise and help will be greatly appreciated.

 

Thanks,

Brian

WR2.stl