[Ultimaker Cura 4.6.1]

Oooh. Okay, good to know ! ^^
So if I set line with at .15 for my .2 nozzle and .8 for my 1mm even though the printer is set up for .4mm nozzle it should work ? Thank you very much !

[Ultimaker Cura 4.6.1]

Hi, I'm trying to slice an object on my 0.2mm nozzle for a custom 3D printer (Artillery Genius).
0.4mm nozzle and 1mm nozzle work fine but everytime I try to set up 0.2mm (or 0.25 or 0.3mm) it resets it back to 0.4mm after any change. If I try to slice it, It gets back to 0.4mm and slices at 0.4mm.

Anyone has the same issue ? I'm switching to slic3r for testing purposes but I do like very much Cura Uu

Thank you very much!
Best regards,

Thomas D

[Impression avec buse 0.2mm]

Bonjour, perso j'ai un autre problème, c'est que Cura refuse d'enregistrer ma buze de 0.2mm Aucun problème avec 0.4 et 1mm cependant donc je suis un peu confus. Peut-être que ton problème est similaire cependant ?