Hello,
for my Anet A8 I was using Cura 14.07 in the past which works well.
Now I wanted to retry to use an newer Cura version. So I downloaded Cura 4.6.1.
Of course I tried newer Cura versions in the past (last I tried version 4.3.something). At this time Anet was not supported from scratch and I had to set my own properties for "Custom printer" but I got it never to work. In the newest version I happliy realized Anet A8 is listed in the supported printers.
The only issue I have is my Hoteend will not be adressed with a target temparature. (remains at 0)
When I replace the header of the 4.6.1 GCode with the header of 14.07 GCode evertything is fine.
I attachted a (working) Cura 14.07 version and a 4.6.1 version.
I can't see the issue, because in both versions Command
M109 is executed.
In the 14.07 Version a specific target is defined
M109 T0 S185.000000
But obviously there are some other differences. When I add "T0" to the 4.6.1 GCode command it still remains on zero for target temparature.
Any help is appreciated.
Thank you
Ben
(This are two different Models. So don't wonder about the size)
Cura_4.6.1.gcode Cura_14.07.gcode