Balbers01
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Balbers01
-
-
I appreciate the help, when will the fix be implemented in your build? Thanks!
-
-
I have a 3 in 1 out extruder with a single heater and in cura I have shared heater checked. My issue is that every tool change there is a M109 to set the temperature which triggers the warmup delay (all filaments are the same temp) and yields significantly longer print times. Is there any way to eliminate these temp calls on tool change and just let it stick with the initial temp? I've watched during the change and the temp stays steady at 200 degrees even before the call is made.
Eliminating M109 calls when changing tools/shared heater
in UltiMaker Cura
Posted
Thanks, just installed it and did a test run, doesn't export the temp calls. going to run a test print this week.