barrem01

The 8.3 filename / print from card didn't work for me. I found the job just stopped, almost as if it had completed, but the extruder hadn't been moved away from the piece the way it does on successfully completing a piece. No "Waiting for user" message on the screen. I think it just said "ready". I would estimate the job was about 15% complete. I'm printing the same model via usb now, it's not yet reached the point that the last print failed, but it's given me the "waiting" message twice already. The model in question has a pretty big build plate footprint, but when I was printing 4 face shields on a plate the, extruder moved further from the center of the build plate than it does for the current model. However that may have been with the previous version of Cura. Also I have a tendency to put small models near the corner of the build plate - meaning that even with these small models, the extruder was further from the center of the build plate than with this current model, without triggering the error.