Veroo
-
Posts
9 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Veroo
-
-
-
Hi,
I use Cura 4.8 and it shows a weird FLAT form for my Stl file when it loads it without giving me an error.
Then when I try to slice it gives me an error : Unable to slice
Before I exported to STL I used the 3D print tool box tool to verify it and it did not flag ANY error.
I have checked everything I could think of.
at this point, any Help would be very much appreciated
Thank you!
-
Thanks for trying. I ended up printing it sideways with a support. I wll see if I can find a bridging test gizmo to print. 🙏🙏🙏
-
here is the STL. Thanks for looking at it.
-
Hi, i m new to cura and 3d printing in general.
I printed the shape in the first picture below With 20% infill with no problem. Then I tried with zero infill and just 2 or 3 wall lines (vase mode didn’t work for the shape.) when I ran into a problem at the top of the shape (see the 2nd picture).
I then printed again with the bridge parameters and a 0 as minimum bridge wall lenght (all other parameters I didn’t change) This time although the sides at the top are much better. It seems to still have a problem with the middle portion (rest of the pictures show the printing and final product with the bridge option on). The middle section that it seems to have trouble with is 2 1/2 in long.Any insight as to how to improve this? Especially since I want to print bigger which means bigger bridges.
thanks
-
-
-
Hi I have a CREALITY CR-10 V3 and have set-up CURA for CR-10 (there was option for V2 or V3). Is there something I should know or change for the print to be more specific to my printer? I am having issues with my prints so I want to make sure that I have the printer set-up covered.
Thanks for your help
Cura rejects my STL but Blender 3D print tool box says file is good
in UltiMaker Cura
Posted
it worked ! Thank you Greg!!!