RHSDrafting

The XY calibration just ended with nothing on the buildplate. The printcores kept to the outside of the bed on both sides.

I have manually leveled the printer. I just started the XY offset calibration and it was printing off the bed again. It also stopped after a bit and said the difference between the print cores exceeds realistic values.

Hi, I 'm new to this community. I just purchased the S5 Pro Bundle for my classroom. I have encountered a problem with my first print. The print head runs straight to the front left position and begins to extrude filament for a good bit, then gives me an error about the difference between the print cores. I have upgraded the firmware to the current one and am still having the same issues. Side note, I do have a S5 and 3 extended that work fine. Just curious as to why this one will not work properly out the gate. Thanks in advance.