Jump to content
Ultimaker Community of 3D Printing Experts

yaire

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi, I need to print on a polycarbonate panel of thickness 10 mm, that I stick to the glass build plate. I found out a way to overcome the problem, but I am searching for a way to "tell" the printer to practice active levelling on the panel ( and not on the build plate ). What I am doing for now is: - Z offset at 10mm in Cura - Launch the print WITHOUT the 10 mm panel - Wait until active levelling is finished - Put the panel on the build plate, and the print starts I wish I could tell the printer to practice active leve
×
×
  • Create New...