[Lost printer from Digital Factory]

Hi Chris, Thanks for offering to have a look.

 

Attached to this post is a zip of the key log files form my machine.  I'm interested to hear what you see in them.

 

Thank,  Mike

Mike Log Files.zip

[Lost printer from Digital Factory]

Hi guys.  I was running along fine with my S5 connected to digital factory.  Perhaps a week ago I was not able to see the printer on DF.  Today went to the printer display and disconnected from DF and went thru the re-connection process.  I am still not able to see it on DF.  I can see it fine through the Monitor screen on Cura  Any guidance?

[Material station not respecting eject button]

Ulrich, thanks for the reply.  My use case is a little different right now.  I wanted to retract the filament in order to disassemble and move my system to a different table.  I will let it set to see if it decides to play along.

 

-MHZ

[Material station not respecting eject button]

Hey Everyone,

I have 2 spools in the material station.  My print is finished and I can see that both materials are retracted up into the bowden tubes approximately 2 inches above the cores.

 

I want to remove these two spools.  The eject button lights are blue.  The eject button gives no response when I push it.  I checked the material menu and all buttons are grayed out.  For each material it says it is in use.

 

I have rebooted and have the same situation.

 

What am I missing?  I'm sure its something simple. 

 

Thank you in advance,

 

Mike