[cura 5.6 deutsch]

auf der website wird es nicht angeboten und der autoupdater sagt es gibt kein update.

über die englische seite könnte ich es installieren.

[cura 5.6 deutsch]

gibt es irgendeinen grund warum cura in deutsch bei 5.5 stehen geblieben ist?

[Umlaute aus Dateinamen entfernen]

hi,

 

gibt es ein Addon/eine Möglichkeit  Umlaute aus dem Dateinamen des erzeugten gcodes automatisch entfernen zu lassen?

 

mfg

[Cura prints holes in mid-air]

hi,

 

how can i tell cura not to print the holes first?

https://www.thingiverse.com/thing:2783012

 

 

cheers

[Spiralize watering can fails]

i think i found it

 

in 0.3m layer height cura tried to add a tiny bit of support while in 0.2 it did not.

 

disabling it manually seems to fix it.

 

 

tnx

[Spiralize watering can fails]

tnx,

 

 i tried the 3mf file, but the behavior is the same.

"Outer Wall Inset" and "Horizontal Expansion" and "Horizontal Hole Expansion"

are all set to 0.0

 

All settings are basically defaults.

 

i just noticed when i change from draft (0.3mm) to normal(0.2mm)

it works. seems a bit strange to me.

[Spiralize watering can fails]

hi,

 

cura jumps from the 2 conical tips to the front of the can

instead of following the wall.

which setting might cause this?

 

 

 

https://www.thingiverse.com/thing:4609601

 

 

CHEERS

[use shortest way to bridge]

is there an option to use the shortest way to bridge between two circles?

 

not like in the pic below: