icbm

Switching problem is solved, recalibrating of the switch position was the solution (did not see the possibility in the menu before). Will have a look if the other failures are still remaining... Thanks

Hello, I have two Ultimaker 2 Extended+ and two Ultimaker S5 - Pro Bundles working. I have massive Problems with my S5 Pro Bundle after update from 5.8.0 to 5.8.1. After the update, the printer is not working anymore. 1. The printer is not able to autolevel. The Printhead moves to a wrong position, about 1cm before the right position and can not switch between the printcores anymore. When switching the lever manually during the switching process, the printer continues the levelling and start to print. https://youtu.be/DIaOGmMJT_Q 2. Autoloader doens not work anymore During a printjob, the filament spool in the autoloader gets empty, a second spool ist installed properly but the loader does not switch to the next spool, the whole printjob get stucked. (see attached images) 3. Printer freezed several times after update 4. ER998 - Error Message Until the update everything was fine, I took of the last print from the buildplat before the update. After the update it started with the level error (unrealistic difference from the printcores) because of the wrong position. I have restarted the printer several times, no change. I have reseted the printer to factory, without any result. I went back to firmware 5.7.3, also no change with my problem. Reupdated to 5.8.1 Need a solution to get the printer working again. Thanks, Alex dmesg.log