jhihn

I recently learned that Cura support {variables}, but would like to introduce some randomness to printing. I have a wipe line whose X offset I would like to vary a little each print, If I set X to 20mm, then allow varying up to 10mm, I can make sure they never overlap Similarly, I would like to vary the starting "center" location, by having Cura choose some random offset that would help land the print still fully in the print volume of the printer, but reduce the wear on the bed's center location. Is there a way to do this?

I have a CR-10S which has a BLTouch attached. My current settings do: Heat Bed Heat Nozzle Home Probe Bed Start printing I want to order the first print steps as: Heat Bed Home Probe Bed while heating nozzle Wait for nozzle heated (if needed) Start printing The problem I am having is that while probing I am getting filament oozing from the nozzle, but If I waited until the probe started, then the oozing would at least be less.