Jump to content

gerrul3r

New member
  • Posts

    1
  • Joined

  • Last visited

Posts posted by gerrul3r

  1. Hi out there !

     

    This topic has been a while but I want to share my experience:

     

    I was faced to similar problems, my outer wall didn´`'t connect with the inner wall. I was able to fix this issue a bit more, not perfectly, but acceptable:

     

    Try this:

    - increase the infill overlap to at least 30%

    - enable ironing to smoothen and connect the outer wall to inner parts:

     

    image.png.dd90111b2e6cb8c637643e5e56279653.png 

     

    Since I use this configuration, I had good results by small expenses of increased time and material (around 5-10% ?).

     

    Further settings can be considered:

    - printing temperature increase by a few degrees

    - decreased print speed

    - increase your E-steps for extruding, just a few percent (0,5-1%)

     

    I'm not a professional, but experimenting with above values @213°C print,63°C bed, PLA on glass-bed (no-adhesion additive) had improved my printing quality a lot.

     

×
×
  • Create New...