Ray_McRay
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Ray_McRay
-
-
- If the print always fails at exactly the same height, check your Z Axis.
- This seems like a very thin and high part, does the wall start to wobble at some point maybe?
- How is general adhesion between layers? Try to increase line width by 10-20%, that way the filament gets "squished" and sticks better to itself.
-
-
-
Disclaimer: I am aware that you're not supposed to print Benchy with support. Just trying to learn/understand the program and experimenting with settings. Thanks in advance!
-
Print fails: layers stop to stick together at some point
in UltiMaker Cura
Posted
Z steps calibration could be another probable solution