[Print fails: layers stop to stick together at some point]

On 12/12/2020 at 4:18 PM, Orange1234 said:

It looks like at some point, the printer doesnt really touch the layer it is printing on anymore, goes a little distance and then touches it again, until it fails completely.

 

 

Z steps calibration could be another probable solution

[Print fails: layers stop to stick together at some point]

- If the print always fails at exactly the same height, check your Z Axis.

- This seems like a very thin and high part, does the wall start to wobble at some point maybe?

- How is general adhesion between layers? Try to increase line width by 10-20%, that way the filament gets "squished" and sticks better to itself.

 

[Why is (nearly) everything 0,2 mm even though I assigned 0,16 mm ?]

4 minutes ago, Smithy said:

Have you maybe enabled Adaptive Layers?

Yes! This was it! Thank you.

This option really should show when you type in "height" in the search bar...

Edit: It does. Facepalm.

[Why is (nearly) everything 0,2 mm even though I assigned 0,16 mm ?]

See Screenshot.

Is there something like "automatic Layer height correction"? How can I turn it off?

P.S.: I am aware that a 0,16 mm is not necessary for this specific part. This is a Test part.

[Why are these supports not connected to anything? How can I fix that?]

Disclaimer: I am aware that you're not supposed to print Benchy with support. Just trying to learn/understand the program and experimenting with settings. Thanks in advance!

[Why are these supports not connected to anything? How can I fix that?]

Sorry if this is a stupid question, I'm new to Cura