A21UNO
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by A21UNO
-
-
I am trying to slice a model in Cura 4.8 but the model shows stripy and when I try to slice I get the following message, Unable to slice, Please review settings and check if your model, : fits within the build plate, : are assigned to an enabled extruder, : are not all set as modifier meshes. The model does fit within the build plate, I have only one extruder so assume it is permantently enabled, I have not had trouble printing other models. I'm not sure I understand the last one but I am only trying to slice one model so assume there's nothing to set there. I did have this problem with another model and when I enable a brim the message went and the model turn to yellow, however this doesn't work with this particular model . Can anyone help please?
Error message in Cura 4.8 Can anyone help
in UltiMaker Cura
Posted
Thank you for your help, you appear to be right, reading the link you sent I can see my model is in the dark area of the bed. I have encountered this before using Prusa Slicer and simply increased the bed size in the machine settings. I have done this in Cura but now I can see that the print area does not increase, only the outer area around the print area.
My print bed is 220 x 220 and my model is 220.2 x 219 so I will have to go back to the drawing board and try to reduce the size a little.
Once again, thank very much. Graham.