AlfredTheGrey2
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by AlfredTheGrey2
-
-
5 hours ago, gr5 said:
So you tried this? It worked perfectly as desired?
Unfortunately no, the problem still remain, i'm desperate 😭
-
12 hours ago, GregValiant said:
Still over 10 hours to print. I just kept fooling with it. 7% grid infill.
The angled area is still kind of random. Z-seam is "User Specified", "Front", "Seam Corner Preference" = None.
Not a bad idea for the time being, but i think in some print with thin walls could lead to structural weakening in that point
-
17 hours ago, gr5 said:
Strange. Your stl and gcode aren't helpful. Instead post the project file. Do "file" "save...". Then post that here.
Make sure "enable retraction" is checked.
Make sure "maximum retraction count" is 10 or greater and "minimum extrusion distance window" is less than 5.
Make sure "retraction minimum travel" is less than 5mm.
Check "max comb distance with no retract". Not sure if the latest cura has this setting only the burtoogle versions.
"Combing mode" is not on "off"?
I wanted to reduce the printing time by removing all the unnecessary travel moves and make them pass inside the infill lines, because when finished, the print will be inaccessible inside and some times all those travel moves create inside it little debris that you can hear while shaking it.
-
4 hours ago, gr5 said:
Strange. Your stl and gcode aren't helpful. Instead post the project file. Do "file" "save...". Then post that here.
Make sure "enable retraction" is checked.
Make sure "maximum retraction count" is 10 or greater and "minimum extrusion distance window" is less than 5.
Make sure "retraction minimum travel" is less than 5mm.
Check "max comb distance with no retract". Not sure if the latest cura has this setting only the burtoogle versions.
"Combing mode" is not on "off"?
Every option you said was already good but the problem still persist, this happen with all my prints
-
I'm really strugling to eliminate travel lines inside this print and really don't undestand why, the combing mode is active and the printer head should travel inside the infill lines but this doesn't happen.
Support Eraser
in UltiMaker Cura
Posted
Can you actually make the eraser cube smaller ?