A handful of versions back the profile for the Anycubic Mega S changed the start-of-print behaviour to wipe the nozzle at the edge of the bed rather than printing a line slightly inboard of the border. This seemed like an improvement at the time, but now that location of the bed has begun getting damaged. It seems as though the edge of the coating has been lifted up or removed now, and that area has slowly been getting larger. How would I return it to the old behaviour? I'm assuming this is some change in the pre-print gcode but I do not know what to change or what to change it to. The behaviour itself probably isn't a problem, but rather the location of it has made it problematic. If it could be moved inboard from the border slightly again it would probably be fine. I think it is only an issue because it is doing the wipe right at the edge, and can affect the edge of the bed coating as a result. I would imagine if it did the same thing a few mm inboard nothing would go wrong. How would I change the gcode to move it inward a few mm? Thanks.