[Unable to retract faster than 200mm/s]

I have decided to use firmware retraction instead, thanks for your help.

[Unable to retract faster than 200mm/s]

>Whatever you set it to will be affected by E-Accel

I only retract about a mm, perhaps I'm not getting up to speed? 200mm/s did seem awfully high. I have acceleration control disabled in Cura. I'll try retracting something like 20mm to see if I can see it accelerating.

 

I installed the Printer Settings plugin and changing the "Maximum Feedrate" there does not remove the error. Decreasing it does not affect print time until around around 15mm/s, down from 50mm/s.

[Unable to retract faster than 200mm/s]

Cura refuses to slice above 200mm/s