Hello,
First, Im not entirely sure if this is where i can raise concerns. Sorry if this is the wrong place.
I just installed UM2+ Tinkergnome version 17.10.1. I decided to change firmware for the purpose of recovering a failed print. I measured the Z axis using the adjust z position and when i tried the recover print option, it was reading the file for a very long time. I was patient until it reached my set z height. But then its showing Z193.96/ 36.00 (I set 36.00 as Z axis) and seems stuck there. I thought it might be a build issue and tried v 19.03.1 as its the latest option. Same issue persisted.
One thing though, when i looked at the gcode file, i found that MAXZ is set to 34.39. So, is that the issue? So what should i give in recover print?
Kindly help me out.