st2000

... follow up. Instead of trying normal supports, I saw there was a CURA 4.11.0 available. So I upgraded and am trying tree support again. Well, the print has gotten past the point where it was failing before. So it looks like things are better. Also, I noticed that the computer had a problem mounting the SDCard the seconds time. Indicating I may have pulled the SDCard out before the file was completely copied over the first go around. So it may not have been a CURA problem. Unless I've another print failure, I'll leave it at that & assumed I didn't un-mount the SDCard properly.

I have a similar problem. Just upgraded to 4.10.0 so as to have tree supports. But, near as I can tell, the print stops (I think) when the printer starts printing where the tree support touches the plate. I've tried to print the same file generated by CURA 4.10.0 twice. And the printer stops at the same spot both times. I'm going to try CURA 4.10.0 once more w/ordinary supports and report back here.