dmcneil77
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by dmcneil77
-
-
37 minutes ago, GregValiant said:
You didn't mention how many walls are showing. Check that you don't have "Spiralize outer contour" checked. Although it would leave just a single wall.
The bottom is showing, as well as all sides of the cube except for the top. I'll check the Spiralize Outer Contour setting. Hopefully that's what it is.
-
52 minutes ago, dmcneil77 said:
Hi everyone. I just installed 4.13.0, upgrading from 4.12.0. When I go to preview mode after slicing a print, the infill is not being displayed. I have resliced some old files that I know have infill, but there is nothing. Also, for models that definitely have a top, like a 40mm Calibration Cube, the top layer is not displayed. The preview basically looks like it has zero infill and no top, like it's just a hollow box. I have gone to settings and checked the "Force Layer View Compatibility Mode" box, as I saw that solution in a previous thread. I've restarted Cura, but to no avail. Infill and top layer simply will not display in Preview Mode. Please let me know if you need further information for a solution to this.
UPDATE: I just tried printing a 40mm XYZ Calibration cube and it is hollow. Just the bottom and outer walls printed. No Infill and no Top. What am I missing here? I've looked over all of my settings and nothing has changed since I updated to 4.13.0. Any ideas are welcome, because without infill, my printer is useless.
-
Hi everyone. I just installed 4.13.0, upgrading from 4.12.0. When I go to preview mode after slicing a print, the infill is not being displayed. I have resliced some old files that I know have infill, but there is nothing. Also, for models that definitely have a top, like a 40mm Calibration Cube, the top layer is not displayed. The preview basically looks like it has zero infill and no top, like it's just a hollow box. I have gone to settings and checked the "Force Layer View Compatibility Mode" box, as I saw that solution in a previous thread. I've restarted Cura, but to no avail. Infill and top layer simply will not display in Preview Mode. Please let me know if you need further information for a solution to this.
Ultimaker Cura 4.13
in UltiMaker Cura
Posted
THANKS! That fixed it! I usually don't display every setting because I only use a few of them on a regular basis. After I made every setting visible, I noticed quite a few that were activated. Spiralize Outer Contour was activated as well. I appreciate your help and getting back to me so quickly!