UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Before retraction it gives extra amount of filament of about 1mm at high speed, and than it retracts my 12mm but of course with no success.
Wipe is configured to travel 2mm inside the printing but it does not so i turned it off.
Cura-4.11
Ender3-v2
Retraction I want: travel given distance inside printed area(best 1 circle) while retracting given mm filament at given speed, then travel and then shift the filament with given speed over yet printed area back.
Retracting more than 5mm gives no better result!
I think that this 1mm push causes the bad retraction ?
Befor retraction extra amout of filament
in UltiMaker Cura
Posted · Edited by bastl
Hello
Before retraction it gives extra amount of filament of about 1mm at high speed, and than it retracts my 12mm but of course with no success.
Wipe is configured to travel 2mm inside the printing but it does not so i turned it off.
Cura-4.11
Ender3-v2
Retraction I want: travel given distance inside printed area(best 1 circle) while retracting given mm filament at given speed, then travel and then shift the filament with given speed over yet printed area back.
Retracting more than 5mm gives no better result!
I think that this 1mm push causes the bad retraction ?
Any hint is welcome...
Many thanks in advance !