[PVA printing issues, adhesion or BBcore problems?]

Im having the same problem on my s3 and just got an s7, first test with PVA printed ok and the second one failed (material error) after about 5 layers.  Will try the tension on the new machine and see if it works.

[Error: Failed writing to specific cloud printer: "printername" not in remote clusters.]

Not sure why Cura 5.7 is giving me this error: Failed writing to specific cloud printer: MSiLabS3wifi not in remote clusters.

Bug in the new version?

[Save to removable - no longer an option]

USB stick works, sd card reader pluged into the same port shows in explorer but not in cura. Using 5.5.1 beta btw.

[Save to removable - no longer an option]

Tried both of the above solutions, neither works.  Not sure what is going on with it.

[Save to removable - no longer an option]

I recently had to change the drive letter on my SD card reader and now Cura 5.5.1 will not show "save to removable drive"  Is there a way to remap cura to the new drive letter?

[AA print core stuck]

I had a similar problem with a stuck core, ABS didn't stick to the bed and clogged up the entire head.  While clearing out the ABS (by heating with a heat gun to help) the ABS pulled the wires from the back of the core.  Is there a wiring diagram available to get this core back up and running?  It is difficult to tell on other cores where the 4th wire goes.

[Stuck in "Heating Up..." Mode]

Got it!  It is back in business!

Thanks again!

[Stuck in "Heating Up..." Mode]

Upon further investigation, one of the cables that connects to the bed is severed!  I assume I can just strip the wire and reconnect?

[Stuck in "Heating Up..." Mode]

And yes, it is  2 Extended +

[Stuck in "Heating Up..." Mode]

gr5 Thanks for the troubleshooting!  It turns out the bed is not heating.  What is the next step?

 

[Stuck in "Heating Up..." Mode]

I am having the same issue, the machine gets stuck "heating up" phase once a design is loaded.  I unplugged the machine and waited an hour, still same issue.  

Any suggestions on a fix would be great.

 

Thanks

[2E+ Stepper Motor Slipping]

I am looking for some help with an issue of the x-axis stepper motor slipping.  The printer makes a grinding sound, I get "Limit Error 07" Machine does "home", but during the print the design drifts to the left. 

Any help would be much appreciated!