UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have this weird problem. There are some STL files I just can't get to print as the Gcode generated by Cura makes the hotend go at coordinates 250 on Z and 220 on X. Then the bed start moving and the filament is dropped in mid air.
If I stop the print and start another gcode I know works fine. It does exactly the same. I need to remove the memory card and turn of the printer and then restart it before inserting the memory card to be able to print again.
I already have the latest firmware from Creality.
Here are an example of the files I get problems with.
Ender 3 V2 goes directly at 250 on the Z axis and 220 on X axis before starting to print
in Improve your 3D prints
Posted
I have this weird problem. There are some STL files I just can't get to print as the Gcode generated by Cura makes the hotend go at coordinates 250 on Z and 220 on X. Then the bed start moving and the filament is dropped in mid air.
If I stop the print and start another gcode I know works fine. It does exactly the same. I need to remove the memory card and turn of the printer and then restart it before inserting the memory card to be able to print again.
I already have the latest firmware from Creality.
Here are an example of the files I get problems with.
Here is my setup:
Stock Ender 3 V2 except for the bed springs.
Creality firmware 1.0.4
Eryone Red PLA+ 1.75mm filament
CE3_4010_Lightweight_Duct_Standard_Right.gcode 4010_Lightweight_Duct_Standard_Right.stl CHEP4.11_0.20(Good).curaprofile