Howdy Y'all, I am trying to to use Cura slicer for WAAM. To say I have hit some hurdles would be an understatement. The first technical challenge I have ran into is overlap setting. For successful laying of welds there has to be a relatively large overlay between beads. I have looked through Cura and can not find any settings that specifically allow me to dictate the overlap between skin and walls. I also am not sure if Cura is capable of calling a weld start or stop opposed to retraction and extrude. I am not super code savvy and do not have the ability to personally modify Cura. Has anyone had luck with Cura for WAAM?