[Weird slicing issue]

9 hours ago, GregValiant said:

It's the Zseam where the outer layer starts and stops.  Cura marks the location with that white line.

Within the Wall settings are options you can try to move it.  When that model gets above the cutouts it will hide on an edge, but down low where it is round it's tough because there aren't any corners to stick it in.  Try User Specified and then Front and Smart Hiding.

All right awesome I will give it a try later when I get home. Is it typically something most people just sand off?

[Weird slicing issue]

It seems that everytime I go to slice this helmet it places a line across the outside of the helmet. Printed out a mando helmet and same issue occurred. Can always sand it down but rather have the smooth print. Any suggestions???

[Problem slicing]

It seems that everytime I go to slice this helmet it places a line across the outside of the helmet. Printed out a mando helmet and same issue occurred. Can always sand it down but rather have the smooth print. Any suggestions???