[Neither "Pause at Height" or "Filament Change" work on my Ender 3]

GregValiant

 

Your 1st suggestion to try using the "Gcode after pause" box in Pause at Height worked fine. I never had to go any further to try the others.

 

Thanks! 

[Neither "Pause at Height" or "Filament Change" work on my Ender 3]

Thanks  I'll give this a try tomorrow morning. I'll let you know if it works. 😉 

[Neither "Pause at Height" or "Filament Change" work on my Ender 3]

As the title says, I cannot get "Pause at Height" or "Filament Change" to work on my Ender 3 v1.

 

"Filament Change" does nothing for me. :(

 

"Pause at Height" does nothing either, unless I modify the gcode and replace the M0 entries to M25. Then it will stop printing, and move the print head out of the way for only a few seconds. I have no time to change the filament. Is there a setting I am missing? Is there a gcode command that will make it pause a set amount of time? or one that requires an action from me to restart?

 

I haven't been able to find an answer anywhere.

 

My Printer is a Creality Ender 3. I believe it is a version 1. The motherboard says 4.2.2  and the chip is a STM32F103RCT6.