[tree support checkbox missing]

thanks for you post. 

[tree support checkbox missing]

HI,

I was watching a video on tree supports using CURA, 

Under experimental - I can't find a Tree Supporting setting. 

I did a search in setting for "Tree" in settings I found the following; please see attached. 

 

Could there be another setting which would prevent access the tree supports? 

[ArchiCAD model won't print.]

Do you know a good adhesive for sticking ABS? Which is easy to clean, no residue over time?

[ArchiCAD model won't print.]

Greg,

Thank you very much for your help. 

But I reached out to my 3D printer supplier - They said to format the SD card.

 

I've began printing the lower layers of the model!

[ArchiCAD model won't print.]

The initial skirt is in centre of bed before it stops 

[ArchiCAD model won't print.]

But the thing is, it does not effect my other prints, they print in centre of bed no problem....

[ArchiCAD model won't print.]

So you can actually print my Model?

 

The 150mm offset I changed when setting up the machine to align print to centre of bed. 

It was printing on the corner of bed when I first set it up (from memory). 

 

[ArchiCAD model won't print.]

STUDIO REV 2.3mf

[ArchiCAD model won't print.]

Hi Greg,

Thanks for your post. 

After I posted I realised what your saying about scaling down will make some components to thin to print.

 

I've adjusted the model so every item is at least 1mm thick. When slicing the windows & door don't disappear. 

 

But I'm having the same problem as before. The printer does the shirt and then stalls for some reason an won't go any further.  the control of machine goes too, it seems stuck. I have to switch off the machine and turn back on to cancel print.

 

When I change to another model it can print? it's bizarre.  

STUDIO MODIFIED -THICKER WIN & DOORS.stl

[ArchiCAD model won't print.]

Im new to the forum, so could someone please le me know if I've posted my question in the correct forum or sub-forum?

[ArchiCAD model won't print.]

HI,

I've converted an Archicad model into a .STL & for some reason it won't print. 

 

I can print other items, so I don't think it's the printer. 

 

Can someone have a look at the model and let me know where the problem is? 

 

I have a Creality Ender -3  MAX. 

Archi - model.stl