[Schedule a print start time?]

This is a real great feature.
One tip: there is way to send the job with the build in API (you need authentication to send a PUT request attach the printjob file).  You can then schedule the print with Postman or other API tools from your computer.

[S5 Frame Light]

On 10/10/2018 at 4:12 PM, Shadowman said:

Hi SandervG

 

I have fine this several times and nothing changes.

 

The leds remain on constantly; bright while printing and low light when in

resting state as shown in the pictures.

 

Thank you 

 

Hi, some 4 years later and I have this problem also on my new S5. The led stays on full brightness no matter what setting and reset. Have you resolved this issue ? 

[Ultimaker S3 Frame Light Brightness control does not work]

Thanks for the reply !

[Ultimaker S3 Frame Light Brightness control does not work]

On 12/28/2021 at 5:48 PM, mrts said:

@Dim3nsioneer - I tried a whole printer reset, and firmware reinstalls (both most stable and latest firmware). I'll try..

I have the same exact problem. But only on the S5. Have you resolved the issue ?

[Material Station Lights]

I have a really strange problem with the Material Station light and the printer case leds. I see the menu on the touch panel to dimm or on/off when printing. But it only controls the led of the material station and not the printer case. The printer case is always on and really shining through the room.

• I tried to only power on the printer it self (without material station and air manager). The control led brightness doesn't responding. You can slide to low/high brightness but, but nothing happening to the led in the printer case. 
• I put everything together (material station and air manager) still no control over the led in the printer case. 
• Then headed over the control in the web interface, put it on "unavailable" still the led in the print case is on.
• Then headed to the API and the response say 100. I tried to lower it to 20. It succeed, but the led is still not changed, the API is responding a wrong value I guess.
• I am on the latest firmware.

Anyone else some solution ?