Since my home is the back right corner and the bed raised all the way up, I wonder if the gcode thinks my home is somewhere else, such as the front left corner and is just hitting the stops for x and y. Also I did locate the home offset on my machine is X:146.198mm, Y: 73.497mm, and Z 0mm. Toolhead offset is X: 33.387mm, Y: -0.074mm. I am not sure why that would impact it as those numbers have never been changed since I owned the machine, but I figure it is worth bringing up. I will try to connect my printer via USB and jog it using my computer, maybe that would provide some results.