UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am currently using Cura 5.2.1 with 0.4mm nozzle, 0.2 layer height & 0.4 line width.
Is it possible to remove or reduce the gaps between the lines?
Normally this is not an issue but recently it has been on a few of my prints making them weak at line joints & I would like to have a better surface finish too.
I have attached a screen shot from Mainsail G-Code viewer. I have pointed out some of the gaps I am talking about. The part in this picture is small, only 15x20mm, to exaggerate the point.
I know a smaller linewidth would help but I don't really want to have to do that as it makes it a much longer print.
Gaps between lines
in UltiMaker Cura
Posted
Hi,
I am currently using Cura 5.2.1 with 0.4mm nozzle, 0.2 layer height & 0.4 line width.
Is it possible to remove or reduce the gaps between the lines?
Normally this is not an issue but recently it has been on a few of my prints making them weak at line joints & I would like to have a better surface finish too.
I have attached a screen shot from Mainsail G-Code viewer. I have pointed out some of the gaps I am talking about. The part in this picture is small, only 15x20mm, to exaggerate the point.
I know a smaller linewidth would help but I don't really want to have to do that as it makes it a much longer print.
Any suggestions welcome & thanks in advance.